Fast-return walkway finish
- Prepare, clean and make good the surface
- Apply minimum 2 coats of Rayson UraForce HY15, overcoating within the recoat window
Rayson UraForce · Hybrid urethane
Rayson UraForce HY15
Rayson UraForce HY15 is a single-component, water-based hybrid urethane — a self-crosslinking acrylic-copolymer-enhanced polyurethane — that roller-coats concrete and mineral surfaces with a fast-drying, stain-resistant, anti-slip finish.
ConcreteCement screed TDS RY-TDS-705
Best for
Best for quick-turnaround coloured floor coating on walkways, playgrounds and commercial areas where single-pack simplicity and fast drying matter.
UraForce HY15 packs urethane performance into a one-can product. The self-crosslinking acrylic-copolymer-enhanced polyurethane needs no hardener or mix ratio — open, stir and roll — which removes the most common site errors and suits maintenance teams as well as applicators.
The film dries fast with well-balanced hardness and durability, and delivers good stain resistance, easy cleaning, low dirt pick-up, good abrasion resistance, anti-slip performance and water repellence. It is non-yellowing and suitable for interior or exterior use on grey concrete, stone, limestone, pavers and cementitious coatings.
Overcoating is possible in as little as 1–3 hours at 25 °C, with light traffic in roughly 4–6 hours — a genuinely fast programme for occupied sites and overnight windows.
In Malaysia
Supplied by Epovex Coatings Sdn. Bhd., Company No. 202601042128 (1704223-A). The Malaysia launch is scheduled for 1 March 2027; confirm availability and lead time for your project. Installation through an authorised applicator in Johor, Kuala Lumpur or Penang introduced by Rayson, who quotes and warrants the workmanship, or by your own crew with Rayson’s application guidance.
Send an enquiryKey benefits
- Single component — no mixing errors, minimal wastage
- Fast-drying: overcoat in 1–3 hours, light traffic in 4–6 hours at 25 °C
- Stain-resistant, easy-to-clean, anti-slip finish
- Non-yellowing, interior or exterior use
Recommended uses
- Coloured coating over acrylic polymer cementitious coatings (APCC)
- Grey concrete walkways and commercial floors
- Hard surfaces such as stone and limestone
- Pavers, playgrounds and basketball courts
Application
- Brush
- Roller
| Specification | Data sheet value |
|---|---|
| Mixing | Single component, ready to use; pot life stated as under 4 hours once opened and in use |
| Drying and curing | Overcoat in 1–3 hours at 25 °C (substrate dependent); open to light traffic after 4–6 hours |
| Pack sizes | 24 kg plastic pail |
Typical systems
Anti-slip external ramp
- Prime and texture with Rayson GripSafe AP12 anti-slip primer filler
- Finish with Rayson UraForce HY15 in the selected colour
Limitations
- Ambient and surface temperatures must be at least 5 °C above the dew point
- Recommended wet film thickness approximately 130–150 microns per coat
- A thin-film finish, not a levelling or heavy-duty build product
- Shelf life shorter than two-pack products — rotate stock
Not suitable for
- Heavy industrial or forklift traffic — use an epoxy or PU-cement system
- Chemical spill or containment areas
- Levelling uneven substrates — it is a thin roller coat
Used with
Jobs and industries
Jobs that use Rayson UraForce HY15
Rayson-authorised applicators in Johor, Kuala Lumpur and Penang install Rayson UraForce HY15 on these jobs and in these industries; its layer is marked in each build-up. Each page shows how the work runs, what to send for a quotation and what decides the price.
Floor systems, laid by an applicator or bought direct
All floor systems ↗ 01 Rayson system
PU flooring
PurScreed PC70 PU-cement screed for hot, wet and chemical floors, and six UraForce PU coatings, clear or coloured, indoors and out; laid or sold direct.
- PurScreed PC70 PU-cement screed, 1.5–3 mm
- Concrete slab, prepared, coves and drains detailed
Colour that must not yellow in daylight: UraForce WB58 over an R50 body coat. Outdoors: UraForce SB72 over PrimeBond S30. The concrete look: UraForce WB60 or SB65, clear.
Quoted after inspection 02 Rayson system
Sports court painting
Basketball, tennis and multi-purpose courts and playgrounds coated in CourtFlex AC25, with GripSafe AP12 texture and UraForce HY15 for walkways; laid or sold direct.
- CourtFlex AC25 court colour, at least two coats
- GripSafe AP12 texture, where the court needs grip
- Concrete or asphalt court, cracks and ponding repaired
Line marking after the colour coats. Playgrounds and walkways: UraForce HY15 over GripSafe AP12.
Quoted after inspectionJobs in Johor
03 Rayson system
Anti-slip floor treatment
Ramps, walkways, porches, pool decks and wet rooms made safe underfoot.
- GripSafe AP12 quartz anti-slip texture
- Concrete or asphalt, cleaned and keyed
Colour: UraForce HY15 over AP12. Coated floors: quartz broadcast into the epoxy finish. Glazed tiles: a tile treatment, quoted on inspection.
Quoted after inspectionBy industry, across Malaysia
Industries we cover ↗ 04 Rayson system
Hospital, clinic and care home floors
Corridors, service areas, kitchens, laundries, wet rooms, ramps and car parks in hospitals, clinics and care homes, laid in occupied buildings.
- Tiles, re-laid after the ponding test
- Tile bed
- SealForce WB20, two coats, turned up the walls
- Screed to falls
- Floor slab
Corridors and service areas: LevelShield SL120 or FloorGuard R50. Rooms that reopen the same day: UraForce WB52 over PrimeBond W10. Kitchens and laundries: PurScreed PC70. Walls: UraForce WB58.
Quoted after inspection 05 Rayson system
School and kindergarten floors
Classrooms, corridors, halls, walkways, playgrounds, courts, toilets, canteens and roofs in schools and kindergartens, done in the school holidays.
- UraForce WB58 topcoat, colour-stable
- FloorGuard R50 epoxy in a colour from the range
- PrimeBond E20 epoxy primer
- Concrete floor, keyed and repaired
Walkways, ramps and playgrounds: GripSafe AP12, coloured with UraForce HY15. Courts: CourtFlex AC25. Toilets: SealForce WB20 under the tiles.
Quoted after inspection The practical details
Rayson UraForce HY15: questions people ask
Does UraForce HY15 need a hardener?
No — it is a single-component, self-crosslinking product. Stir well and apply; there is no mix ratio to get wrong.
How fast can an area reopen?
Indicatively, light foot traffic after 4–6 hours at 25 °C, with overcoating possible from 1–3 hours.
Is it slippery when wet?
The finish is formulated with anti-slip character, and for ramps or wet zones it pairs with GripSafe AP12 textured primer for a defined anti-slip profile.
Can it be used outdoors?
Yes — it is non-yellowing and suitable for interior or exterior use, including playgrounds, pavers and walkways.
How many coats are recommended?
A minimum of two, with dull patches receiving a further coat for a uniform finish.
Start a conversation / ↗
Send the job, or ask for materials
Tell us what the surface is, where it is and what it has to withstand. Rayson replies with a system recommendation; for installation, the applicator for your area in Johor, Kuala Lumpur or Penang is introduced to quote the job.
Malaysia launch: 1 March 2027. Enquiries are welcome now; supply, site assessment and installation timing are confirmed for each project.